Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1998REGAL 25TH ANNIVERSARY EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM - REMOTEPROGRAMMING PROCEDURESTRANSMITTER PROGRAMMINGWITH SCAN TOOL
1998 Buick Regal 25th Anniversary Edition
With Scan tool
1998 Buick Regal 25th Anniversary EditionSECTION With Scan tool
- Connect scan tool to Data link Connector (DLC).
- Turn ignition to RUN position. At APPLICATION MENU, select "F3" (BODY CONTROL MODULE).
- At BODY CONTROL MODULE menu, select "F3" (SPECIAL FUNCTIONS).
- At SPECIAL FUNCTIONS menu select "F0" (OUTPUT CONTROL).
- At OUTPUT CONTROL menu, select "F5" (program key fobs).
- Follow directions on scan tool to program transmitters. Press EXIT repeatedly until APPLICATION MENU screen is viewed.
- Disconnect scan tool from DLC. Verify system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.