Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B2802: RFA Link Circuit (Short To Ground): Description
When any button on keyless entry transmitter is pressed, a radio frequency signal is sent to Remote Control Door Lock Receiver (RCDLR). RCDLR then decides which message to send the BCM (according to which button was pressed), which will allow BCM to operate door lock actuators, courtesy lights or remote alarm.
DTC B2802 will set when BCM detects a short to ground in circuit No. 917 (Black wire) for more than 0.3 second. No driver warning message will be displayed.
If conditions for malfunction no longer exist, history DTC will clear after 100 consecutive ignition cycles. DTC B2802 will also clear when conditions for malfunction no longer exist or scan tool is used to clear codes.
- TESTS W/CODES - Century
- TESTS W/CODES - Regal
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.