Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK1996ROADMASTER BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES)WHEEL ALIGNMENT SPECIFICATIONS

1996 Buick Roadmaster Base

Wheel Alignment Specifications

1996 Buick Roadmaster BaseSECTION Wheel Alignment Specifications

WARNING: This page is about a different car, the 1996 Cadillac Fleetwood. However, it is still accessible from the selected car via links, so may be relevant.

WHEEL ALIGNMENT SPECIFICATIONS

Application

Preferred

Range

Camber ⁽¹⁾

-1.5 To 1.5

Caster ⁽¹⁾

Left

3.25

2.25 To 4.25

Right

3.75

2.75 To 4.75

Toe-In ⁽¹⁾

0.16

-0.4 To 0.36

Toe-In ⁽²⁾

0.08 (2.0)

-0.02 To 0.18 (-0.5 To 4.5)

⁽¹⁾	Measurement is in degrees.

⁽²⁾	Measurement is in inches (mm).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.