Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
The Idle Air Control (IAC) valve is controlled by the PCM. PCM uses the IAC to maintain a desired idle speed, which can vary depending on input to PCM and other criteria. If PCM detects that idle speed is out of IAC systems range of control at idle, it will perform an active test while the vehicle is being driven.
During this test, PCM will command the IAC valve to move while monitoring MAF. If the expected change in MAF is detected, and IAC operation is verified, but since idle RPM was out of IAC system control and IAC valve is working, DTC P0507 will set. DTC P1509 will set, when there is no change in MAF, and IAC valve is not functioning and idle RPM is out of IAC system control.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.