SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1996ROADMASTER BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM - REMOTETESTINGREAR GLASS RELEASE AVAILABLE WITH IGNITION SWITCH IN RUN
1996 Buick Roadmaster Base

Rear Glass Release Available With Ignition Switch In Run

1996 Buick Roadmaster BaseSECTION Rear Glass Release Available With Ignition Switch In Run

POSITION & TRANSMISSION OUT OF PARK

  1. Disconnect RCDLR connector C1. Turn ignition switch to RUN position. Connect test light between RCDLR connector C1 terminal "B" (Pink wire) and ground. If test light lights, go to next step. If test light does not light, repair open or short to ground in Pink wire.
  2. Set parking brake. Shift transmission to Drive. Connect test light between connector C1 terminal "C" (Light Green wire) and ground. If test light lights, check for short to voltage in Light Green wire. If Light Green wire is okay, replace transmission position switch. If test light does not light, check for poor connection at keyless receiver connector C1 terminal "B" (Pink wire). If connection is okay, replace RCDLR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.