Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1995REGAL GRAN SPORTREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONFRONT SUSPENSIONSUSPENSION - FRONTTORQUE SPECIFICATIONS
1995 Buick Regal Gran Sport
Torque Specifications
1995 Buick Regal Gran SportSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft/ Lbs. (N.m) | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Axle Shaft Nut | (1) 184 (250) | |||||||||
| Ball Joint Stud Nut | (2) | |||||||||
| Ball Joint-To-Steering Knuckle Bolt (4) | (3) | |||||||||
| Brake Caliper Slide Mounting Bolt | 80 (108) | |||||||||
| Frame-To-Body Bolt | (4) 125 (170) | |||||||||
| Hub & Bearing Assembly Bolt | 60 (81) | |||||||||
| Lower Control Arm Pivot Bolt | 52 (70) | |||||||||
| Stabilizer Bar-To-Control Arm Bolt/Nut | 35 (47) | |||||||||
| Stabilizer Bar-To-Frame Bolt/Nut | ||||||||||
| 28-mm & 30-mm Bar | 35 (47) | |||||||||
| 34-mm Bar | 27 (37) | |||||||||
| Steering Shaft Pinch Bolt | 35 (47) | |||||||||
| Strut Closure Nut | 82 (111) | |||||||||
| Strut Mount Cover Plate Nut | 24 (33) | |||||||||
| Strut Shaft Upper Nut | 82 (111) | |||||||||
| Tie Rod Nut | 63 (85) | |||||||||
| Wheel Lug Nut | 100 (140) | |||||||||
|
||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.