Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1995LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSNORMAL SERVICE97500 MI OR 156000 KM
1995 Buick LeSabre V6-3.8L VIN K
97500 MI or 156000 KM
1995 Buick LeSabre V6-3.8L VIN KSECTION 97500 MI or 156000 KM
Lubricate
Steering and Suspension
Every 7,500 miles or 12 months. Inspect components.
Shift Linkage, A/T
Parking Brake Cable
Cable guides only.
Reset
Oil Change Reminder Lamp
Reset whether "change oil" light has came on or not. (if equipped)
Clean
Antenna
Check
Lighting and Horns
Hood Latch
Inspect
Throttle Cable/Linkage
Seals and Gaskets, Drive Axles
Fluid - A/T
Check fluid level and add fluid as necessary.
Coolant
Constant Velocity Joint Boot
Brakes and Traction Control
Inspect lines, hoses, brake pads, rotors, brake linings, parking brake and other brake parts.
Replace
Engine Oil
Every 7,500 miles or 12 months or when "Change Oil" light comes on. (If equipped).
Rotate
Tires
Tire and wheel inspection and rotation.
Steering and Suspension
Every 7,500 miles or 12 months. Inspect components.
Shift Linkage, A/T
Parking Brake Cable
Cable guides only.
Reset
Oil Change Reminder Lamp
Reset whether "change oil" light has came on or not. (if equipped)
Clean
Antenna
Check
Lighting and Horns
Hood Latch
Inspect
Throttle Cable/Linkage
Seals and Gaskets, Drive Axles
Fluid - A/T
Check fluid level and add fluid as necessary.
Coolant
Constant Velocity Joint Boot
Brakes and Traction Control
Inspect lines, hoses, brake pads, rotors, brake linings, parking brake and other brake parts.
Replace
Engine Oil
Every 7,500 miles or 12 months or when "Change Oil" light comes on. (If equipped).
Rotate
Tires
Tire and wheel inspection and rotation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.