PCM Connector C-D (White)

1995 Buick LeSabre V6-3.8L VIN KSECTION PCM Connector C-D (White)
POWERTRAIN CONTROL MODULE (PCM) VOLTAGE CHART
This PCM voltage chart is for use with a digital voltmeter to further aid in diagnosis. The voltages you get may vary due to low battery charge or other reasons, but they should be very close. The B+ symbol indicates a nominal system voltage of 12-14 volts.

CONDITIONS FOR TESTING
^ Engine at operating temperature (upper radiator hose hot).
^ Engine idling in "Closed Loop" (for "Engine Run" column) in park or neutral.
^ Test terminal not grounded.
^ Scan tool not installed.
^ Accessories "OFF."

NOTE: Before checking voltages, be sure PCM and engine grounds are clean and tight.

CHART LEGEND
* Less than 0.5 volts.

** If equipped.

*** Foot off brake.

(1) B+ for 1st 2 seconds.

(2) Varies.

(3)Varies with temperature.



WHITE 32 PIN CONNECTOR

32 Pin C-D Connector (WHITE):




Powertrain Control Module (PCM) Connector (White C-D):




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.