Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1990REATTA 2D CONVERTIBLE, 4T60/ME9REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - TESTS W/CODES - ECMMANUAL OPERATION OF SERVICE MODEOVERRIDE DISPLAY CODE DEFINITIONSECM OVERRIDE PARAMETERS
1990 Buick Reatta 2D Convertible, 4T60/ME9
ECM Override Parameters
1990 Buick Reatta 2D Convertible, 4T60/ME9SECTION ECM Override Parameters
- ES00 No Overrides display will not show any value in display area on ECCP, as no overrides are active at this point. This is normal resting code where no overrides will be controlled. This code can be used to stop override control without having to go back to system selections.
- ES01 TCC solenoid display will show commanded state of TCC solenoid (00-not engaged, 99-engaged). Pressing UP arrow button will engage TCC and pressing DOWN arrow button will disengage TCC. Vehicle must be in 3rd or 4th gear for override to operate.
- ES02 EGR solenoid #1 can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES03 EGR solenoid #2 can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES04 EGR solenoid #3 can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES05 Canister purge solenoid can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES06 A/C RELAY can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES07 Cooling fan relay #1 can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES08 Cooling fan relay #2 can be turned OFF (00) by pressing DOWN arrow button or turned ON (99) by pressing UP arrow button.
- ES09 IAC MOTOR display will show position IAC motor is being commanded to in percentage of travel. Vehicle must be in Park or Neutral. DOWN arrow button will retract motor (increasing RPM) and UP arrow button will extend motor.
- ES10 Injector control override will work only when vehicle is in Park or Neutral. When entering override, display will show "0", all injectors will be working normally. UP arrow button will increment display by 1, up to 6 (or to 8, for 8 cylinder engine), and then return to "0". Display number indicates cylinder injector number that is being held off. Injector will continue to be held off until DOWN arrow button is used to turn injector back on. DOWN arrow button is used to toggle injector, ON and OFF.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.