Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Control System
Electronic control system monitors engine operating conditions, processes the information, and controls engine for optimum performance and minimum emissions. Input signals are generated by the Coolant Temperature Sensor (CTS), Mass Airflow (MAF) sensor, exhaust Oxygen (O2) sensor, Throttle Position Sensor (TPS), Power Steering Pressure Switch (PSPS), Park/Neutral switch, Vehicle Speed Sensor (VSS), Manifold Air Temperature (MAT) sensor and Manifold Absolute Pressure (MAP) sensor.
Some engines may use a combination of MAT and MAP sensors in place of MAF sensor. The MAT and MAP sensors are used to determine airflow. The ECM may also receive signals from starter solenoid during cranking mode, air conditioning selector switch and distributor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.