Programmer Indexing: Notes

1987 Buick Regal Grand NationalSECTION Notes
PROGRAMMER ELECTRICAL INDEXING

Application Programmer
Regal
Heater Control Valve A
A/C B
Defroster C
Heater D
Recirc. E
Ignition F
Skyhawk
Open A
Recirc. B
Defroster C
A/C D
Heater E
Ignition F
  1. Check voltage at appropriate pin in 22-pin control panel connector. If voltage is less than 2 volts, check electrical connections and wiring between control panel and programmer. If voltage is more than 2 volts, replace control panel.
  2. Check voltage at appropriate pin in 22-pin control panel connector. If voltage is more than 2 volts, check electrical connections between control panel and programmer. If less than 2 volts, replace control panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.