Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1987REGAL GRAND NATIONALREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETUNE-UPIGNITION SYSTEM - HEI-ESTTESTINGHALL EFFECT SWITCH TEST
1987 Buick Regal Grand National
Hall Effect Switch Test
1987 Buick Regal Grand NationalSECTION Hall Effect Switch Test
NOTE:
Hall Effect switches cannot be checked with an ohmmeter.
- Disconnect 3-wire connector at Hall Effect switch. Connect a 12 volt battery and voltmeter to switch terminals. See Fig 1. Carefully note polarity markings.
- Insert knife blade straight down between magnet and Hall Effect switch. See Fig 1. Voltmeter should read within 0.5 volts of battery voltage. With knife blade removed, voltmeter should read between 0 and 0.5 volts. If voltage readings are not as specified, replace Hall Effect switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.