Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Angle Gauge Adjustment Tool
Manufacturer recommends that some carburetor adjustments be performed using a choke valve angle gauge (Kent-Moore tool no. J-26701). While preparations and actual adjustments may vary with individual adjustment, the procedure for using the angle gauge to check the choke valve angle remains the same. Use the following procedure to perform ADJUSTMENTS requiring the use of the choke valve angle gauge.
- Rotate degree scale on angle gauge so that 0° mark is opposite pointer.
- With choke valve closed, place angle gauge magnet squarely on choke valve.
- Rotate leveling bubble on angle gauge until it is centered.
- Rotate degree scale until specified degree mark is opposite pointer.
- Now perform individual ADJUSTMENT preparations as outlined in the following carburetor adjustments requiring angle gauge. If bubble is centered, adjustment is correct. If not, adjust carburetor as outlined.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.