Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1982REGAL SPORT, TRANS MFR CD 350C/MX5REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSCOMPUTER COMMAND CONTROLDIAGNOSIS & TESTINGCCC DIAGNOSISEXITING DIAGNOSTIC MODE
1982 Buick Regal Sport, Trans Mfr CD 350C/MX5
Exiting Diagnostic Mode
1982 Buick Regal Sport, Trans Mfr CD 350C/MX5SECTION Exiting Diagnostic Mode
To exit diagnostic mode, turn ignition off and remove spade lug terminal from ALDL connector.
NOTE:
The terms "enter diagnostics" and "exit diagnostics" will be used periodically throughout this section. Follow the procedure for entering diagnostic mode when instructed to "enter diagnostics". Follow the procedure for exiting diagnostic mode when instructed to "exit diagnostics".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.