Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1982REGAL SPORT, TRANS MFR CD 350C/MX5REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWINDOW DEFOGGER GRIDTESTINGSYSTEM TEST
1982 Buick Regal Sport, Trans Mfr CD 350C/MX5
System Test
1982 Buick Regal Sport, Trans Mfr CD 350C/MX5SECTION System Test
- Check that all in-line fuses or circuit breakers are operational. Turn ignition and defogger control switch to "On" position. Rear window glass should feel warm to touch after three minutes of operation. If glass does not warm, use a test lamp or ohmmeter and check for 12 volts at feed wire to window grid at rear connector. The location of feed wire connector varies. It will be found either near the left or right upper corner of glass or in the rear compartment by the rear seat back, and will be either a Purple or Black wire depending on model. If voltage is correct, and window is not warm, check rear window grid wires as described in this story. If voltage is not correct, check wiring harness, control switch or timer/relay.
- Test defogger control switch for shorts and replace switch if it is shorted. Some switches must be removed from panel to perform check. Check system for correct operation. If system is inoperative install a new relay/timer (locations vary) and check operation of system. If system does not operate, locate and repair short in the wiring circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.