Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Window Control Switch
Connect one lead of test lamp to Pink wire in switch connector, the other end to ground. If lamp does not light, check power feed wire. Locate wires to motor. Using jumper wires, connect Pink wire in switch connector to one motor wire, and ground the other wire on all but Camaro, Firebird, and Corvette. Motor should operate. Reverse wires and retest. If motor operates properly, replace switch. If not, test motor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.