Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1982LESABRE ESTATE WAGON V8-307 5.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSIDLE SPEED CONTROL ASSEMBLY - REPAIR KIT
1982 Buick LeSabre Estate Wagon V8-307 5.0L
Idle Speed Control Assembly - Repair Kit
1982 Buick LeSabre Estate Wagon V8-307 5.0LSECTION Idle Speed Control Assembly - Repair Kit
Model Year 1982
Bulletin No. 82-I-237
File in Group 64A
Number 37
Date Feb. '83
SUBJECT: Idle Speed Control Assembly Repair Kit
MODELS AFFECTED: All 1981, 1982 Gasoline Engines
A revised gear and shaft has been released for 1982 production Idle Speed Control Assemblies. Idle Speed Control Assemblies with the new gear and shaft may be identified by a yellow dot on the housing near the shaft:
In order to provide these improvements to the service assemblies, two
(2) separate service repair packages have been released to repair 1981 and 1982 Idle Speed Control Assemblies (I.S.C.). Applications are as follows:
Part Number Application
17079749 For "J" Series Equipped
With Engine Code "G"
17079750 All Other Engines
The repair kits contain a gear and shaft assembly, a boot, grease, and an instruction sheet.
The repair packages are to be used only if the following condition exists:
Idle Speed Control Assembly runs forward and reverse, but plunger does not extend or retract properly.
WARRANTY INFORMATION
Use applicable Labor Time Guide I.S.C. Assembly R & R
*Kit Installation .3 Hr.
* Other Labor Hours
Bulletin No. 82-I-237
File in Group 64A
Number 37
Date Feb. '83
SUBJECT: Idle Speed Control Assembly Repair Kit
MODELS AFFECTED: All 1981, 1982 Gasoline Engines
A revised gear and shaft has been released for 1982 production Idle Speed Control Assemblies. Idle Speed Control Assemblies with the new gear and shaft may be identified by a yellow dot on the housing near the shaft:
In order to provide these improvements to the service assemblies, two
(2) separate service repair packages have been released to repair 1981 and 1982 Idle Speed Control Assemblies (I.S.C.). Applications are as follows:
Part Number Application
17079749 For "J" Series Equipped
With Engine Code "G"
17079750 All Other Engines
The repair kits contain a gear and shaft assembly, a boot, grease, and an instruction sheet.
The repair packages are to be used only if the following condition exists:
Idle Speed Control Assembly runs forward and reverse, but plunger does not extend or retract properly.
WARRANTY INFORMATION
Use applicable Labor Time Guide I.S.C. Assembly R & R
*Kit Installation .3 Hr.
* Other Labor Hours
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.