Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1980CENTURY BASE, 3.8L ENG VIN AREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSMODEL IDENTIFICATION
1980 Buick Century Base, 3.8L Eng VIN A
Model Identification
1980 Buick Century Base, 3.8L Eng VIN ASECTION Model Identification
Repair procedures in this article are identified by body type. The following table lists GM division, model name, and body type. Only cars with power windows are listed.
| GM Division | Model Name | Body Type |
|---|---|---|
| Buick | Century, Regal | A |
| Chevrolet | El Camino, Malibu, Monte Carlo | A |
| Oldsmobile | Cutlass | A |
| Pontiac | LeMans, Grand Prix, Grand Am, Grand LeMans | A |
| Buick | Estate Wagon, LeSabre | B |
| Chevrolet | Impala, Caprice | B |
| Oldsmobile | 88 | B |
| Pontiac | Bonneville, Catalina | B |
| Buick | Electra | C |
| Cadillac | Fleetwood, DeVille | C |
| Oldsmobile | 98 | C |
| Cadillac | Limousine | D |
| Buick | Riviera | E |
| Cadillac | Eldorado | E |
| Oldsmobile | Toronado | E |
| Chevrolet | Camaro | F |
| Pontiac | Firebird | F |
| Cadillac | Seville | K |
| Buick | Skylark | X |
| Chevrolet | Citation | X |
| Oldsmobile | Omega | X |
| Pontiac | Phoenix | X |
| Chevrolet | Corvette | Y |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.