Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dual & Single Acting Tailgates
Remove tailgate panel cover and watershield. Remove both access hole covers. Operate window to a point that sash channel cam attaching bolts are accessible. Remove right and left cam attaching bolts. Slide cams to disengage regulator life arm rollers and remove cams from tailgate. Pull window straight out to remove it from tailgate. Disconnect wire harness at regulator motor connector. Remove bolts securing regulator to support and remove regulator with motor attached. To install, reverse removal procedure.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.