Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1967SKYLARK NOT AVAILABLE, 6.6L ENG, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETUNE-UPTUNE-UPMODEL IDENTIFICATIONENGINE NUMBER
1967 Buick Skylark Not Available, 6.6L Eng, Not Available Trans
Engine Number
1967 Buick Skylark Not Available, 6.6L Eng, Not Available TransSECTION Engine Number
See TUNE-UP .
CAPACITIES (COOLING)
| Model | Without Air Cond. | With Air Cond. | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Special, Skylark V6 | 10 1/2 qts. | 11 qts. | |||||||||
| V8 | (1) 12 qts. | (3) 14 qts. | |||||||||
| GS 400 | (2) 16 qts. | 17 qts. | |||||||||
| LeSabre | (1) 13 3/4 qts. | 14 3/4 qts. | |||||||||
| Wildcat, Electra, Riviera | (4) 16 qts. | 17 qts. | |||||||||
|
|||||||||||
CAPACITIES (EXCEPT COOLING)
| Crankcase | (1) 4 qts. | |||||||
| Synchro-mesh 3-Speed | 3 1/2 pts. | |||||||
| 4-Speed | 3 pts. | |||||||
| Super Turbine "300" | (2) 19 pts. | |||||||
| "400" | (3) 23 pts. | |||||||
| Rear Axle (Special, Skylark, GS 400, LeSabre) | 2 3/4 pts. | |||||||
| (Wildcat, Electra, Riviera) | 4 1/4 pts. | |||||||
| Fuel Tank (Special, Skylark, GS 400) | 20 gal. | |||||||
| (LeSabre, Wildcat, Electra) | 25 gal. | |||||||
| (Riviera) | 21 gal. | |||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.