V8 Engines: 1971-73

1965 Buick LeSabre Base, 2D Convertible, Eng CD LL, Standard TransSECTION 1971-73

Engine and transmission must be removed as a unitΒ  .

  1. Remove hood and disconnect battery cables, all wires, water hoses, vacuum hoses and exhaust pipes. Remove radiator, shroud, fan and pulley. Remove air cleaner and disconnect accelerator linkage.
  2. Remove fuel line at fuel pump. Disconnect A/C and power steering components and position to one side with hoses attached. Remove propeller shaft.
  3. With Synchro-mesh Trans, disconnect clutch linkage at cross-shaft, then remove cross-shaft at frame bracket. Connect lifting tackle to take weight off front mounts and remove front mount through bolts.
  4. Remove rear mount to crossmember bolts. Raise engine to take weight off rear mount, then remove crossmember.
  5. Lift engine slightly, move forward and remove from car.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.