Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2023X4 M40IREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPSUNROOF -- REPAIR (G02)
2023 BMW X4 M40i
Sunroof -- Repair (G02)
2023 BMW X4 M40iSECTION Sunroof -- Repair (G02)
- 54 10 General Information
- 54 13 Sunroof
- 54 13 001 Adjusting front glass slide/tilt sunroof panel
- 54 13 002 Adjusting glass slide/tilt sunroof panels
- 54 13 007 Adjusting rear glass slide/tilt sunroof panel
- 54 13 050 Replacing gasket on rear glass slide/tilt sunroof panel
- 54 13 052 Replacing gasket on front glass slide/tilt sunroof panel
- 54 13 055 Replace gasket for panorama glass roof frame
- 54 13 086 Removing and installing panorama roof
- 54 13 087 Replacing the panorama roof
- 54 13 090 Removing and installing/replacing wind deflector
- 54 13 240 Removing and installing/replacing front glass slide/tilt sunroof panel
- 54 13 250 Removing and installing/replacing rear glass slide/tilt sunroof panel
- 54 13 516 Replacing the mechanism for the glass slide/tilt sunroof panel (panorama glass roof removed)
- 54 13 548 Replacing roller sunblind (Headlining lowered)
- 54 13 701 Replacing drive cable, glass slide/tilt roof panel (panorama roof removed)
- 54 13 711 Replacing drive cable, roller sunblind (Headlining lowered)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.