Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2023M4 CSLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (ABS/TRACTION CONTROL - REPAIR (E46))TORQUE SPECIFICATIONS
2023 BMW M4 CSL
Torque Specifications
2023 BMW M4 CSLSECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 34 other vehicles, including the 2004 BMW M3, 2004 BMW 330xi, 2004 BMW 330i, 2004 BMW 330Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Banjo Bolt For Pre-Boost Pump Intake Line To Pre-Boost Pump | 15 (20) | |
| Brake Line Couplings | 13-14 (17-19) | |
| Pressure Sensor "H" Or "V" | 11 (15) | |
| Pressure Sensor To Hydraulic Unit | 14 (19) | |
| Wheel Lug Bolts | 81-96 (110-130) | |
| INCH Lbs. (N.m) | ||
| Bracket, Hydraulic Unit To Body | 71 (8) | |
| Bracket To Hydraulic Unit | 71 (8) | |
| Bracket, Rotation Rate Sensor To Body | 71 (8) | |
| Control Unit On Hydraulic Unit | ||
| MK 20 | 23 (2.6) | |
| MK 60 | 44 (5) | |
| 4WD | 26 (2.9) | |
| Pulse Sensor To Swivel Bearing/Wheel Carrier | 71 (8) | |
| Rotation Rate Sensor To Bracket | 71 (8) | |
| Screws To Preboost Pump & Holder | 71 (8) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.