Installing both front-end struts

2023 BMW 530eSECTION Installing both front-end struts
NOTE: Description is for right component only. The procedure on the left side is identical.

Installing the front-end strut 

  • Install the front-end strut (3).
NOTE: RISK OF DAMAGE 
Use of an incorrect tool (impact screwdriver) to release and tighten the screws. 
Damaged thread. 
  • Only use a standard tool (e.g. reversible ratchet) to release/tighten the screws.
G14457536Courtesy of BMW OF NORTH AMERICA, INC.
  • Clean the thread at shock tower.
  • Replace the screw (1).

    Parts:  Screw

  • Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS

Front-end strut to cross connection 
Hexagon screw
Replace screw.
Joining torque  28 Nm
Angle of rotation  90°
  • Replace the screw (2).

    Parts:  Screw

  • Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS

Front-end strut/strut brace 
Screw
Replace screw.
Tightening torque  56 Nm
Angle of rotation  90°
  • Repair the damaged thread on the shock tower with a Helicoil insert.
CONSUMABLE SPECIFICATIONS

Helicoil thread insert  M10x30 mm 07129909659
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.