Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2023330E XDRIVEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 188 (GENERAL ORPHAN DATA (1 OF 2))DISASSEMBLING ALL SPECIAL TOOLS
2023 BMW 330e xDrive
Disassembling all special tools
2023 BMW 330e xDriveSECTION Disassembling all special tools
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Release screws (4) from the special tool set 2 456 372 .
- Guide the setting gauge 0.5° (2) out of the special tool 2 456 372 between the exhaust camshaft and the basic carrier (1) and remove.
- Guide the setting gauge 0.7° (3) out of the special tool 2 456 372
between the intake camshaft and the basic carrier (1) and remove.
- Release screws (1) from the special tool set 2 456 372 .
- Guide the basic carrier (2) out of the special tool 2 456 372
and remove.
- Guide the special tool 2 288 380
out and remove.
- Guide the special tool 0 493 380 (11 6 480)
out and remove.
- Guide the special tool (1) 2 455 654
out and remove.
- Release screws (4) from the special tool set 2 456 372 .
- Feed setting gauge 0.5° (2) out of special tool 2 456 372 between exhaust camshaft and basic carrier (1) and remove.
- Feed setting gauge 0.7° (3) out of special tool 2 456 372
between intake camshaft and basic carrier (1) and remove.
- Release screws (1) from the special tool set 2 456 372 .
- Guide the basic carrier (2) out of the special tool 2 456 372
and remove.
- Guide the special tool 2 288 380
out and remove.
- Guide the special tool 0 493 380 (11 6 480)
out and remove.
- Guide the special tool (1) 2 455 654
out and remove.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.