Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 62 Senders for Control Unit
2023 BMW 228i Gran CoupeSECTION 13 62 Senders for Control Unit
WARNING: This page does not describe the selected car, but rather 38 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
SENSOR FOR CONTROL UNIT TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Temperature time switch | M21 / M51 | 18 Nm | ||
| 2AZ Coolant temperature sensor | M60/1 / M60/2 / M21 / M51 | 18 Nm | ||
| All others | 13 Nm | |||
| 3AZ Temperature switch | All | 28 Nm | ||
| 4AZ Temperature sensor - air | All | 13 Nm | ||
| 5AZ Charge-air pressure sensor on holder | M51 / M41 | 4Nm | ||
| Charge-air pressure sensor on intake manifold | M47 | 5 Nm | ||
| 6AZ Twin temperature sensor (4-pin plug-in connection) | M41 / M43/ M44/ S50/ S52/ M52/ M57/ M67/ M62/ M73 | 13 Nm | ||
| 7AZ Air-mass sensor on lower section of air filter housing | M51 | 3.5 Nm | ||
| Air-mass flow sensor to cylinder head cover | M47/ M47TU/ M57/ M57TU | 4.5 Nm | ||
| 8AZ Pulse generator, camshaft to cylinder head cover | M57 | 4.5 Nm | ||
| M47TU/ M57TU | 3.5 Nm | |||
| 9AZ Intake neck on air-mass flow sensor | M47 | 9 Nm |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.