Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Frame Reference Body Dimension Rep-UEB-RAI0141-4106100 - V.1
Dimensions in mm.
Dimensional tolerances:
- ≤ 1000 mm ± 1.5 mm
- ≥ 1000 mm ±2.5 mm
The control points shown serve to check the body and the set of attachments.
The specified dimensions always refer to the centrepoint of the bore/screw.
Underbody view 1
Underbody view 2
Top view, front end
The specified dimensions refer to removed assemblies.
Underbody view, front end
The specified dimensions refer to removed assemblies.
Underbody view, rear end
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.