Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Gap Dimensions Rep-Rep-RAI0141-4106200 - V.2
The dimensions specified in this service information are applicable at an object temperature of 20°C. The aim of adjustment is to achieve a uniform gap .
Symmetry of the gaps between left and right sides of the vehicle has top priority .
For door gaps, the maximum deviation between the front and rear door gaps must be 1.0 mm .
No gap dimensions are specified for components/gaps which cannot be adjusted .
Dimensions in mm
No range of adjustment between side panel and front bumper cover.
- Slide/tilt sunroof lid
- Roof
Height over the entire cover width must lie within tolerance.
The lateral distance between the slide/tilt sunroof lid and the roof must be approximately the same on the left and right.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.