Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installing the low beam sensor
2021 BMW Z4 sDrive M40iSECTION Installing the low beam sensor
- Feed the low beam sensor (1) in the bracket (2) in the arrow direction.
- Press in the low beam sensor (2) at the retaining spring (3) in the center.
- Successively press down the retaining springs (4) on each side to lock it.
- Connect connector (1) .
- Check if air pockets are visible.
Visible shades (1) and (2) are not air pockets but rather the optical element of the sensor. The shades do not represent any functional limitation.
Follow-up work
- Refer to INSTALLING INTERIOR REARVIEW MIRROR .
- Refer to INSTALLING THE COVERS FOR THE INTERIOR REARVIEW MIRROR .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.