Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2021X6 SDRIVE40IREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASETRANSFER CASE -- REPAIR (G06)
2021 BMW X6 sDrive40i
Transfer Case -- Repair (G06)
2021 BMW X6 sDrive40iSECTION Transfer Case -- Repair (G06)
- 27 00 Transfer Case Oil
- 27 10 Transfer Case
- 27 10 010 Removing and installing the transfer case (X6 xDrive40i 2020)
- 27 10 010 Removing and installing the transfer case (X6 xDrive40i 2021-)
- 27 10 020 Installing the exchange transfer case (X6 xDrive40i 2020)
- 27 10 020 Installing the exchange transfer case (X6 xDrive40i 2021-)
- 27 10 070 Replace the output flange at the rear of the transfer case (X6 xDrive40i)
- 27 10 200 Replacing bellows or centrifugal disc on the transfer case (X6 xDrive40i 2020)
- 27 10 200 Replacing bellows or centrifugal disc on the transfer case (X6 xDrive40i 2021-)
- 27 10 730 Replacing the control unit for transfer case (longitudinal torque module) (after vehicle diagnosis) (X6 xDrive40i)
- 27 10 010 Removing and installing the transfer case (X6 M50i)
- 27 10 020 Installing the exchange transfer case (X6 M50i)
- 27 10 070 Replace the output flange at the rear of the transfer case (X6 M50i)
- 27 10 200 Replacing bellows or centrifugal disc on the transfer case (X6 M50i)
- 27 10 730 Replacing the control unit for transfer case (longitudinal torque module) (after vehicle diagnosis) (X6 M50i)
- 27 21 Transfer Case / Drive Shaft Seal
- 27 21 010 Replacing the radial shaft seal for the drive shaft (X6 xDrive40i)
- 27 21 020 Replacing radial shaft seal for output flange (X6 xDrive40i)
- 27 21 040 Replacing the radial shaft seal for the actuator shaft (X6 xDrive40i)
- 27 21 010 Replacing the radial shaft seal for the drive shaft (X6 M50i)
- 27 21 020 Replacing radial shaft seal for output flange (X6 M50i)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.