Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBMW2021740IREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSGENERAL ELECTRICAL SYSTEM -- REPAIR (G12) (2 OF 2)61 31 SWITCH, SENSOR61 31 023 REMOVE AND INSTALL/REPLACE START-STOPPING BUTTONREMOVING THE START-STOPPING BUTTON

2021 BMW 740i

Removing the START-STOPPING button

2021 BMW 740iSECTION Removing the START-STOPPING button

Preliminary work

Refer to REMOVING THE DECORATIVE STRIP ON THE RIGHT DASHBOARD .

Push the START-STOPPING button from the front.
First loosen the upper detents.
Then loosen the lower detents.
Remove the START-STOPPING button (1) from the decorative trim.

G12676271

Courtesy of BMW OF NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.