Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2020840I XDRIVE 2D CONVERTIBLEREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERENGINE ELECTRICAL SYSTEM -- REPAIR (G14, G15, & G16)12 14 ENGINE CONTROL MODULE, SENSORS12 14 700 CODING THE CONTROL UNIT (DME)
2020 BMW 840i xDrive 2D Convertible
12 14 700 Coding the control unit (DME)
2020 BMW 840i xDrive 2D ConvertibleSECTION 12 14 700 Coding the control unit (DME)
Switch off ignition.
Connect diagnostic system.
Switch the ignition on.
Select "coding" program.
Follow the instructions in the diagnostic system.
Adjust the following control units:
- EWS (electronic immobilizer)
- DME (Digital Motor Electronics)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.