Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2018X5 XDRIVE50IREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSAUDIO, NAVIGATION, ANTI-THEFT, AIRBAG CONTROL - REPAIRON-BOARD COMPUTER, OUTSIDE TEMPERATURE SENSOR65 81 060 REMOVING AND INSTALLING/REPLACING OUTSIDE TEMPERATURE SENSOR
2018 BMW X5 xDrive50i
65 81 060 Removing and installing/replacing outside temperature sensor
2018 BMW X5 xDrive50iSECTION 65 81 060 Removing and installing/replacing outside temperature sensor
Necessary preliminary tasks:
- Partially remove WHEEL ARCH COVER AT FRONT LEFT
Unfasten plug connection (1) and disconnect.
Pull out outside temperature sensor (2) from air duct (3).
Installation note:
Check for secure seating after fitting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.