Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and installing (replacing) control unit for contactless tailgate opening
Necessary preliminary work:
- Remove REAR BUMPER PANEL TRIM .
Removal:
Unlock all connectors (1) on control unit (3) and disconnect.
Release screw (2) and thread control unit (3) out.
Installation:
Thread control unit (3) in and tighten with screw (2).
Connect all connectors (1) to control unit (3).
Installation note:
Make sure all plug connections (1) are fitted correctly.
Make sure control unit (3) is fitted correctly.
Make sure connecting line is routed correctly.
Required follow-up work:
- Fit REAR BUMPER PANEL TRIM .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.