Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and installing/replacing control unit for Top-/Rear-/Side-View Camera
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL MECHANISM .
Unlock all plug connections and disconnect.
Unlock latch mechanisms (1).
Remove control unit (2) from holder (3) downwards.
Installation note:
Guide (1) on control unit (2) must be correctly inserted in corresponding recess on counter support.
Make sure control unit (2) is securely seated.
Replacement:
- Carry out PROGRAMMING/ENCODING .
- Calibrate REVERSING CAMERA .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.