Fluid - ASMT

2013 BMW M3 Convertible (E93) V8-4.0L (S65)SECTION Fluid - ASMT



The content of this article reflects the changes identified in TSB-280308.

GS7D36SG 7 Speed M-DCT
Fluid type DCTF-1

Important:
The M Double-Clutch Transmission (DCT) requires a special lubricant/hydraulic fluid: DCTF-1 Pentosin (P/N 83 22 2 147 477). This fluid is specific to the double-clutch transmission and should not be substituted with any other product.

Substituting the DCTF-1 Pentosin in M Double-Clutch Transmission (GS7D36SG) may cause significant damage to the internal clutches of the transmission assembly, requiring replacement of the complete gearbox, transmission oil cooler, and cooler lines.

The BMW DCTF-1 Pentosin fluid does not require regular service. It is an extended-life type of fluid and should not be replaced. Currently the fluid is in extremely short supply, and can be obtained only after a PuMA case is submitted to TeileClearing (Enhanced Technical Support).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.