Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBMW2013650I 2D COUPEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWINDOW MOTORS & REGULATORSGENERAL ELECTRICAL SYSTEM - REPAIR - F13WIRING HARNESS, REPAIR CABLE61 11... INSTALLING REPAIR CABLE FOR LEFT SIDE VIEW CAMERA

2013 BMW 650i 2D Coupe

61 11... Installing repair cable for left Side View camera

2013 BMW 650i 2D CoupeSECTION 61 11... Installing repair cable for left Side View camera

Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES .

NOTE: Work is shown on the F10 by way of example. There may be differences in detail in the case of other vehicle types and equipment specifications.

Necessary preliminary tasks:

Remove FRONT WHEEL ARCH COVER (FRONT SECTION)
Remove SEAL MOUNTING for engine compartment lid
Remove FOOTWELL SIDE TRIM PANEL ON A-PILLAR, LEFT
Preliminary work is described in REMOVE ALL-ROUND VISION CAMERA CONTROL UNIT , do not remove all-round vision camera control unit.
Remove FRONT SEAT on the driver's side
Remove backrest side section on rear seat backrest.
Remove BACKREST
Remove bottom trim panel for door post

NOTE: Required preliminary may vary according to vehicle type and equipment.

Lever expanding rivets (1) out of cover (2).

Remove cover (2).

Installation note:

If necessary, replace damaged expanding rivet.

Make sure holders (3) are correctly seated.

Fig 1: Identifying Expanding Rivets, Cover And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock the lock (1) in direction of arrow with suitable tool.

IMPORTANT: Risk of damage.

Unlock the lock (3) carefully with a suitable tool. Pull connector housing (4) of line (2) in direction of arrow.

Installation note:

Pay attention to encoding (5).

Fig 2: Pulling Connector Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Connect repair cable (2) to Side View camera (1).

Lay repair cable (2) in direction of arrow along wiring harness (3) and secure at points marked with an arrow.

Fig 3: Identifying Side View Camera, Repair Cable, And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws from expansion tank (5) and set expansion tank to one side.

Lay repair cable (1) in direction of arrow along wiring harness (4) and secure at points marked with an arrow.

IMPORTANT: Risk of damage to wiring harness.
Carefully feed repair cable (1) through grommet (2).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.