Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
67 31... Notes on initialization of electric seat actuator drives
2013 BMW 650i 2D ConvertibleSECTION 67 31... Notes on initialization of electric seat actuator drives
NOTE:
Initialization is carried out at the adjusting switch of the relevant seat. In this process, the end positions of the relevant electric seat actuator drive are recorded and stored.
Operating procedure for initialization:
Move corresponding seat actuator drive(s) into both end positions.
An initialization must be performed:
- After replacing a drive unit for seat adjustment.
- After replacing/programming control unit for seat adjustment.
Operating procedure for initialization:
Move corresponding seat actuator drive(s) into both end positions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.