Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 15 (BODY EQUIPMENT - REPAIR (E82))GENERAL51 00... NOTES ON FITTING WINDOW GUIDE SEALSPREPARATIONS
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
51 00... Notes On Fitting Window Guide Seals: Preparations
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Preparations
WARNING: This page is about a different variant/trim than selected.
- Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
- Immediately prior to fitting, clean the work area with spirit in order to remove silicone and grease residuesNOTE: Air drying time approx. 1 minute
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.