Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 71... Removing And Installing/Replacing Multifunction Pan
Necessary preliminary tasks:
- Remove luggage compartment wheel arch trim (left) and Luggage Compartment Wheel Arch Trim (right) .
- Remove battery. See BATTERY .
- Remove battery leads
Release screws (1 and 2).
Remove cover (3).
Release nuts (1) from multifunction pan at bottom. Lay battery wiring harness (2) to one side.
Release nuts (1) and remove multifunction pan.
Tightening torque, see 51 71 9AZ in 51 71 SEALS AND LOOSE BODY PARTS .
Installation:
Seals (1) on multifunction pan (2) must be replaced each time they are removed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.