Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 14... Instructions For Attaching Number/Letter Designation Combination
The model designation is attached with adhesive and cannot be re-used.
The model designation must be attached at room temperature.
The model designation must be removed at stoveenameling temperatures exceeding 80°C.
Removing:
Coat nylon string or strong yarn with tensides (e.g. washing-up liquid).
Cut through adhesive layer and remove model designation (1) from rear lid (2).
Remove remainder of adhesive layer with adhesive remover (sourcing reference: BMW Parts Service).
Assembly:
Number and letter combinations (1) of the model designation are not connected to each other and are supplied on a carrier film (2).
Adhesive areas must be dry and free of dust and grease.
Once it has been cleaned, do not touch the adhesive area with bare hands.
Remove liner (3) (protective strip for adhesive surface).
Press on model designation firmly.
Remove carrier film (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.