41 61... ChECKING HINGE FOR ENGINE COMPARTMENT LID (FOR VEHICLES WITH ACTIVE PEDESTRIAN PROTECTION SYSTEM)

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 41 61... ChECKING HINGE FOR ENGINE COMPARTMENT LID (FOR VEHICLES WITH ACTIVE PEDESTRIAN PROTECTION SYSTEM)
WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:Β 

  • Remove hinge for engine compartment lid

Open and close hinge (1).

Place hinge (1) on a level surface.

Check holes (2) for dimensional accuracy relative to support.

Dimension a=32 mm

Measurement b = 30 mm

Test result Solution
Hinge is stiff Replace hinge
Faulty dimensional accuracy Replace hinge
Fig 1: Checking Hinge For Engine Compartment Lid
G00524325Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.