Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 14 (COLLISION - BODY PANEL REPAIR (E82))BODY PANEL REPAIR41 00... GENERAL CEMENTING INSTRUCTIONS
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
41 00... General Cementing Instructions
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 41 00... General Cementing Instructions
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Conform with safety precautions!
Refer to 41 00... Information On Hazards and/or 41 00... Safety At Work .
- The bonding surfaces must be kept free of all types of dirt and contamination. Avoid leaving fingerprints.
- Cleanliness is the golden rule for all bonds!
- Cleaning agent: isohexane
Expiry date of adhesive:
- The adhesive cartridge is marked with a date.
- Do not use the adhesive after this date.
2-component adhesive application:
- Insert adhesive cartridge in adhesive gun, remove cap and allow some adhesive to emerge. Strip adhesive components uniformly and attach mixing tube.
- Allow approx. 1 mixer length of mixed adhesive to emerge (there must be no smearing of colors). Only then apply the mixed adhesive to one side of the bonding surface.
Adhesive disposal:
- Hardened adhesive is disposed of as normal waste.
- Empty adhesive cartridges are disposed of as normal waste.
- Non-hardened adhesives and mixtures of adhesive and solvent and the like must be disposed of as hazardous waste.
These regulations apply to the Federal Republic of Germany.
For other countries, comply with the (possibly differing) nationally applicable regulations.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.