Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 866 (STEERING AND WHEEL ALIGNMENT - REPAIR)43 ELECTRONIC POWER STEERING32 00... TEACHING IN CENTRE POSITION FOR POWER STEERING (ACTIVE FRONT STEERING) (FROM 03/2007)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
32 00... Teaching In Centre Position For Power Steering (Active Front Steering) (From 03/2007)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 32 00... Teaching In Centre Position For Power Steering (Active Front Steering) (From 03/2007)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out the following procedure after disconnecting the battery or disconnecting electrical plug connections on the steering column switch cluster.
Turn on ignition, start engine if necessary.
Turn steering wheel twice in both directions to full lock.
IMPORTANT:
If the indicator lamp does not go out after the ignition is turned on again, an adjustment of the active front steering
must be carried out.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.