Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 784 (ENGINE - TORQUE SPECIFICATIONS (N54))
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
Section 784 (Engine - Torque Specifications (N54))
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Section 784 (Engine - Torque Specifications (N54))
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
- 11 Engine Block
- 12 Cylinder Head With Cover
- 13 Oil Pump
- 14 Housing Cover
- 21 Crankshaft With Bearing
- 22 Flywheel
- 23 Vibration Damper
- 24 Connecting Rod With Bearing
- 28 V-Ribbed Belt With Tensioner
- 31 Camshaft
- 36 Variable Camshaft Timing
- 41 Oil Pump With Filter
- 42 Oil Filter and Lines
- 51 Water Pump With Drive
- 52 Fan
- 53 Thermostat and Connections
- 61 Intake Manifold
- 62 Exhaust Manifold
- 65 Supercharger With Control
- 66 Vacuum Pump
- 72 Air Pump, Lines and Control Valves
- 78 Emission Control, Oxygen Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.