Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 460 (ENGINE ELECTRICAL SYSTEM - REPAIR)TROUBLESHOOTING12 00 ... INSTRUCTIONS ON COMPONENT INSPECTION
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
12 00 ... Instructions On Component Inspection
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 12 00 ... Instructions On Component Inspection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- During all inspections and work on engine electrics and electronics, always observe safety regulations and accident prevention specifications.
- Always disconnect connectors of control units or components before checking electric wires.
Testing Aids:
- Schematics, refer to Diagnosis Information System (DIS).
- Only ever use test lines, adapters, terminals and test tips manufactured by specialists, refer to Diagnosis Information System.
- The inspection values for component testing are located in the Diagnosis Information System (DIS).
- For further technical information, refer to ENGINE ELECTRICAL SYSTEM - TECHNICAL DATA .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.