Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 435 (HEATING AND AIR CONDITIONING - REPAIR)CONDENSER AND DRYER64 53... NOTES ON REPLACING DRIER BOTTLE OR DRIER INSERT
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
64 53... Notes on replacing drier bottle or drier insert
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 64 53... Notes on replacing drier bottle or drier insert
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
The drier bottle or drier insert does not have to be replaced at regular service intervals in a functioning, leakproof A/C system.
However, the drier bottle or drier insert must be replaced without fail in the event of:
- fouling of the refrigerant by filings/shavings (e.g. when the compressor is clamped)
- a leaking A/C system or loss of refrigerant
- the refrigerant circuit being opened for a period exceeding 24 hours, e.g. during repair work.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.