Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 31 (ELECTRICAL COMPONENT LOCATOR)MOTORS
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
Section 31 (Electrical Component Locator): Motors
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Motors
WARNING: This page is about a different car, the 1998 BMW Z3 and 1998 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.
MOTORS
| Component | Component Location |
|---|---|
| Auxiliary Fan Motor | Behind front grille. |
| Auxiliary Throttle Position Motor (ADS) | On front of engine. |
| Blower Motor | On rear of engine compartment, behind right fresh air intake. |
| Convertible Top Motor | On left side of luggage compartment. |
| Cruise Control Actuator (Tempomat) | On rear left side of engine compartment. |
| E-Box Fan | On right rear side of engine compartment, in E-box. |
| Fresh Air Recirculation Motor | On right side of left footwell. |
| Fuel Pump | In fuel tank. |
| Headlight/Foglight Washer Pump | On front right side of engine compartment, on washer fluid reservoir. |
| Trunk Lock Motor | On rear side of luggage compartment. |
| Washer Pump | On front right side of engine compartment, on washer fluid reservoir. |
| Wiper Motor | On rear of engine compartment. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.