Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 275 Remove and install (replace) control unit Rear Electronic Module (REM)
Necessary preliminary tasks:
Unlock and disconnect all plug connections in area (1).
Unlock and disconnect positive battery cable (3). (Note removal instructions below)
Release screw (2).
Tightening torque: 61 35 4AZ .
Remove control unit (4) from guides (5) in direction of arrow.
Installation note:
Make sure all plug connections are correctly latched.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.