41 00... Reinforcement Plate (Bonded)

In the case of a partial replacement piece, a body component is cut at a point described in the repair instructions.

A reinforcement plate is bonded in to ensure sufficient strength.

Observe notes on repair stage 2. See 41 00... REPAIR TECHNIQUES, REPAIR STAGE 2 .

Mark component in accordance with measurement a and cut.

Fig 1: Identifying Reinforcement Plate Cutting Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Cut new part (1) in accordance with cut on vehicle and if necessary adjust to fit with straightening attachment or universal mount.

Fig 2: Identifying Reinforcement Plate Part In Accordance With Cut On Vehicle

Courtesy of BMW OF NORTH AMERICA, INC.

Make reinforcement plate (1) from trim of new part (2).

Length of reinforcement plate is 80 mm.

Fig 3: Identifying Reinforcement Plate And Trim Of Part

Courtesy of BMW OF NORTH AMERICA, INC.

Slide reinforcement plate (1) half-way into component on body and fasten with 2 self-tapping screws (2).

Fig 4: Identifying Reinforcement Plate Half-Way Into Component On Body, Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust new part (1) to fit and set 4.3 mm dia. bore holes (2).

Remove new part again.

Release self-tapping screws (3).

Remove reinforcement plate.

Drill out bore holes (3) for screws to 4.3 mm dia.

Deburr all bore holes.

Fig 5: Identifying Reinforcement Plate Bore Holes And Self-Tapping Screws

Courtesy of BMW OF NORTH AMERICA, INC.